The Important Role of The Filter for The Equipment

A good filter is equivalent to a human kidney, the engine's three filters are responsible for the filtration of impurities in the engine combustion system, lubrication system, and air intake system.

Even if the diesel fuel is added to the tank before the sedimentation and filtration, in the refueling process, due to the refueling tools, and refueling environment, the tank mouth is not clean and other factors will still make diesel pollution, and the process of diesel engine operation, due to the impurities deposited in the fuel system, air suspended in the sink, will make diesel pollution, so the diesel filter on the car is essential. Different models of cars need to match the different filters, such as the model ar50041 fuel filter.

The use of advanced technology in the common rail system enables the engine to run smoothly and reduces fuel consumption and vehicle cost. Modern injection systems are so precise that their injection holes are too small to fit three hairs. Good filtration optimizes the quality of the diesel fuel in the injection system, resulting in longer system life and more mileage, so filters are an essential part of any diesel system.

How The Filter Works

High-quality diesel filters can well protect the common rail system of diesel engines, thus reducing the use of maintenance costs. At the same time in the process of use, users need to regularly drain, have regular inspections, and timely replacements to ensure the filter filtration effect. Through the following video of the diesel filter introduction, you can understand the working principle of the filter very well.

The Role of The Diesel Filter

The diesel fuel filter is a special diesel fuel purification equipment for diesel fuel for internal combustion engines, which can filter out more than 90% of mechanical impurities, gums, asphaltenes, etc. in diesel fuel, which can ensure the cleanliness of diesel fuel to the maximum extent and improve the service life of the engine. Unclean diesel fuel will lead to abnormal wear of the engine injection system and cylinder, which will reduce the engine power, increase the fuel consumption rapidly, and greatly reduce the generator service life. The use of the filter can make the use of felt filter purifier engine filtration precision and efficiency is greatly improved, so that the life of imported high-quality extended several times, fuel saving effect is obvious, the diesel fuel in the debris removed, to prevent the common rail system blockage, especially the injector nozzle. It can effectively reduce wear and tear, ensure stable operation of the engine and improve the reliability of the engine.

Diesel Filter Replacement

When there is insufficient oil supply to the engine or when the purifier is in suction mode, the pressure gauge pointer points to -0.1MPa When these phenomena occur, it is time to replace the filter.

Filter Replacement Steps

Close the oil inlet ball valve and open the upper-end cap. (Aluminum-type upper-end cover should be gently pried open from the side notch with a flat screwdriver)
Unscrew the drain port plug wire and drain the dirty oil.
Loosen the fastening nut at the upper end of the cartridge, and the operator wears oil-proof gloves to hold the cartridge and remove the old cartridge vertically upward.
Replace the new cartridge with a new one, gasket the upper seal (the lower end has its own gasket), and tighten the nut.
Tighten the drain port plug wire, cover the upper-end cover (pay attention to the gasket), and tighten the fastening bolt.
After the above steps, we can install the diesel filter on the car or large mechanical equipment.

A diesel filter can effectively protect the cylinder and piston, the piston ring protects the injector, and the injection system is a large engine using a clean energy protector. Under normal use, the filter element should be replaced if the differential pressure alarm of the pre-filter device alarms or if the accumulated use exceeds 3000 hours.