Temperature Sensor 102-2240 1309811 4088832 4954574 for Caterpillar CAT Cummins Engine

Temperature Sensor 102-2240 for Caterpillar CAT

The Temperature Sensor 102-2240 for Caterpillar CAT is a device that detects and measures heat and coldness and converts them into electrical signals. The role of the Temperature Sensor 102-2240 for Caterpillar CAT is to convert the temperature change of the gas or liquid into an electrical signal to the ECU, and the ECU receives this temperature signal to carry out the temperature control operation. The temperature sensor assembly is finished and needs to be tested for gas tightness.

MyMRO provides substantial Temperature Sensor 102-2240 for Caterpillar CAT and cummins 5.9 rebuild kit, we always welcome you to buy.

Temperature Sensor 1309811 for Caterpillar CAT

The principle of Temperature Sensor 1309811 for Caterpillar CAT:

The Temperature Sensor 1309811 for Caterpillar CAT is a semiconductor thermistor inside, the lower the temperature the greater the resistance; conversely, the smaller the resistance, the smaller the resistance, the smaller the resistance, the smaller the resistance, the smaller the resistance, the smaller the resistance installed in the engine block or cylinder head on the water jacket, and direct contact with the cooling water. Thus, the temperature of the engine cooling water is obtained. According to this change, the electronic control unit measures the temperature of the engine cooling water. The lower the temperature, the higher the resistance.

MyMRO has an exclusive offer for our customers. The Temperature Sensor 1309811 for Caterpillar CAT is priced at a discount and you can view more about cost of ignition switch.

Temperature Sensor 4088832 for Cummins Engine

The internal Temperature Sensor 4088832 for Cummins Engine is a thermistor that has a fuse to the instrument to 12V voltage through the water temperature sensor grounding water temperature high resistance small water temperature low resistance large thus changing the pointer swing this thing is divided into positive temperature coefficient and negative temperature coefficient two. The electronic control unit is used as a correction for fuel injection and the ignition timing based on the temperature of the engine cooling water measured by this change. Simply put, the temperature of the engine water gives an idea of the current operating state of the engine. Whether it is stopping or moving, or how long it has been moving, etc.

Temperature Sensor 4954574 for Cummins Engine

The Temperature Sensor 4954574 for Cummins Engine work by converting the temperature into a usable output signal using the laws of various physical properties of substances that change with temperature. Temperature sensors are usually installed on the engine, in front of the water tank, or inside the bumper. The Temperature Sensor 4954574 for Cummins Engine is used for safety reasons, and special attention should be paid to driving safety while the vehicle is in motion.

The Temperature Sensor 4954574 for Cummins Engine and fuel shutdown solenoid are well sold on MyMRO, welcoming all purchases.